Evaluation of modulus of elasticity for eco-friendly concrete made with seawater and marine sand
Abstract
The ultimate aim of this study is to use experimental work for evaluating the modulus of elasticity (MOE) of Geopolymer concrete (GPC) using marine sand as fine aggregate and seawater for the mix. Four different groups of concrete mixtures, namely CP1a, CP1b, CP2a, CP2b were identified. While the CP1a mix was prepared using GPC with marine sand and seawater, the CP1b was made by adding sodium sulfate (Na2SO4) into the CP1a mix. The same procedure was applied for CP2a and CP2b mixtures; however, instead of using GPC, Portland Cement was used as the binder for the CP2 group (OPC). A total of 12 test samples were cast and tested to determine the development of MOE of GPC and OPC over time. The MOE of concrete was measured at 3, 7, 28, 60, and 120 days. Experimental results were then compared to the MOE obtained using the empirical equation from ACI 318 - 2008. It was found that the experimental MOE of both OPC and GPC specimens was higher than the estimated MOE values from ACI standards. The added sodium sulfate yielded a significant effect on the MOE of OPC but produced a minimal influence on the MOE of GPC.
Downloads
Copyright (c) 2021 National University of Civil Engineering
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
1. The Author assigns all copyright in and to the article (the Work) to the Journal of Science and Technology in Civil Engineering (JSTCE) – Hanoi University of Civil Engineering (HUCE), including the right to publish, republish, transmit, sell and distribute the Work in whole or in part in electronic and print editions of the Journal, in all media of expression now known or later developed.
2. By this assignment of copyright to the JSTCE, reproduction, posting, transmission, distribution or other use of the Work in whole or in part in any medium by the Author requires a full citation to the Journal, suitable in form and content as follows: title of article, authors’ names, journal title, volume, issue, year, copyright owner as specified in the Journal, DOI number. Links to the final article published on the website of the Journal are encouraged.
3. The Author and the company/employer agree that any and all copies of the final published version of the Work or any part thereof distributed or posted by them in print or electronic format as permitted herein will include the notice of copyright as stipulated in the Journal and a full citation to the Journal as published on the website.
